Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) smr2008-015-006_a TYPICAL 1. Oil pump cover 2. Oil pump screws 1. Pittings on the teeth Using a feeler gauge, measure the clearance be- tween inner and outer rotors. 13. Remove oil pump shaft. 14. Remove outer rotor. 1. Outer rotor 2. Inner rotor smr2006-014-023_a TYPICAL 1. Oil pump shaft 2. Outer rotor Oil Suction Pump Inspection Inspect oil pump shaft, housing and cover for marks or other damages. Check inner rotor for corrosion, pin-holes or other damages. If so, replace oil pump shaft. Ensure to also check oil pump housing and cover and re- place if damaged.
If clearance between inner and outer rotors ex- ceeds the tolerance, replace oil pump shaft. En- sure to also check oil pump housing and cover and replace if damaged. If clearance between outer rotor and its bore in oil pump exceeds the tolerance, replace the com- plete oil pump and the PTO housing. Using a vernier depth gage, measure side wear as shown. smr2009-023 103 OUTER AND INNER ROTOR CLEARANCE SERVICE LIMIT A 0.25 mm (.0098 in) B C