Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) smr2009-023-008_a 1. Screws M6 x 25 2. Screws M6 x 45 1. Oil pump housing surface 2. Vernier depth gage Tighten suction pump cover screws as per follow- ing sequence. 1. Oil pump outer rotor surface 2. Vernier depth gage smr2009-023-009_a TIGHTENING SEQUENCE Difference between pump housing and outer ro- tor should not exceed 0.1 mm (.004 in). If so, re- place the complete oil pump assembly. NOTE: When the axial clearance of the oil pump shaft assembly increases, the oil pressure de- creases. Check the inside of oil pump housing and its cover for scoring or other damages and replace if dam- aged.

Refer to the appropriate procedures and install all other removed parts. OIL SPRAY NOZZLE (SUPERCHARGER) Oil Spray Nozzle Removal Remove the PTO housing. Refer to PTO HOUS- ING AND MAGNETO subsection. Remove the Torx screw securing the oil spray noz- zle support. Unscrew the Banjo bolt. Oil Suction Pump Installation For installation, reverse the removal procedure. Pay attention to the following details. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of the suction pump cover screws and tighten them to 9 N•m (80 lbf• in ). Position screws according to their length as shown. 104 smr2009-023