Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) smr2008-015-007_a 1. Banjo bolt 2. Oil spray nozzle 3. Oil spray nozzle support 4. Torx screw smr2008-015-008_a A. 1 mm (0.039 in) NOTE: Make sure that the oil spray nozzle is fac- ing to the center of the tool. Not following this procedure will lead to an insufficient oiling of the supercharger and a supercharger failure can oc- curs. Adjust the oil spray nozzle if necessary by slightly bending it, take care not to over bend the oil spray nozzle. Oil Spray Nozzle Inspection Check oil spray nozzle for: Dirt Bend Other damages. Replace if necessary. Oil Spray Nozzle Installation For installation reverse the removal procedure.
However, pay attention to the following. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of Torx screw. Install the oil spray nozzle support. Tighten Torx screw to 9 N•m (80 lbf• in ). Install oil spray nozzle with Banjo bolt. Tighten Banjo bolt to 19 N•m (168 lbf• in ). Adjust the position of the oil spray nozzle, by us- ing the SUPERCHARGER OIL SPRAY NOZZLE TOOL (P/N 529 036 134) . smr2008-015-009_a 1. Center of supercharger oil spray nozzle tool OIL SPRAY NOZZLES (PISTONS) The oil spray nozzles are located on the upper half of cylinder block. 529036134 The distance between the adjustment tool and oil spray nozzle must be within 1 mm (.039 in). smr2009-023-012_a 1.
Oil spray nozzles smr2009-023 105