Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) NOTE: When the scope of repair work obligates you to split the cylinder block, take this opportu- nity to clean the oil spray nozzles. Oil Spray Nozzle Installation NOTICE At assembly make sure the contact surface of the oil spray nozzle is well fitted onto the cylinder block. If this is not ensured, the oil spray direction will change, causing potential engine damage. Oil Spray Nozzle Removal Remove cylinder block lower half. Refer to CYLIN- DER BLOCK subsection. Remove oil spray nozzle and Banjo fitting from cylinder block upper half. mmr2009-111-050_a 1. Oil spray nozzle 2. Contact surface mmr2009-111-048_a 1. Banjo fitting 2.

Oil spray nozzle OIL SEPARATOR COVER Oil Spray Nozzle Cleaning and Inspection Clean oil spray nozzle and Banjo fitting from dirt and debris. Use a part cleaner, then an air gun and dry the parts. Check if ball inside Banjo fitting moves freely. Oil Separator Cover Removal 1. Remove the blow-by valve. See procedure in this subsection. 2. Remove camshaft position sensor. smr2009-023-015_a 1. Camshaft position sensor 2. Screw mmr2009-111-049_a 1. Ball 2. Spring 3. Banjo fitting 4. Oil spray nozzle 3. Remove cylinder head cover, refer to CYLIN- DER HEAD subsection. 4. Remove thrust washer from oil separator cover. NOTE:

If the oil spray nozzle is damaged or bent during work in the cylinder block, it must be re- placed immediately. 106 smr2009-023