Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) NOTE: Make sure not to loose thrust washer when removing it from oil separator cover, oth- erwise thrust washer would fall into the PTO housing. smr2006-014-067_a 1. Camshaft 2. Oil separator cover NOTE: Be careful not to break the holding clips from oil separator cover when its removed from the timing gear. smr2009-023-016_a 1. Thrust washer 2. Oil separator cover Oil Separator Cover Inspection Inspect oil separator cover for marks or other dam- ages. Ensure to check also the holding clips of oil separator cover and for thrust washer. If any dam- age is visible replace oil separator cover. 5. Remove spark plug tube. 6.
Remove rocker arm shaft together with rocker arms, refer to CYLINDER HEAD subsection. 7. Remove chain guide and camshaft guide. smr2006-014-066_a 1. Rocker arm 2. Camshaft guide 3. Chain guide smr2006-014-037_a 1. Holding clips Oil Separator Cover Installation For installation, reverse the removal procedure. Pay attention to the following details. Properly install oil separator cover and thrust washer. They need to be in a perfect even posi- tion with timing gear. NOTE: Make sure not to lose thrust washer when installed on oil separator cover. For installation of rocker arm shaft with rocker arms, follow the procedure as it is described in CYLINDER HEAD subsection.
Install all other removed parts. 8. Move camshaft backwards as far as possible. 9. Remove oil separator cover from timing gear by releasing the holding clips. smr2009-023 107