Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) BLOW-BY VALVE Blow-by Valve Description The blow-by valve has two main functions: It recirculates oil vapors. It protects the engine in the event the water- craft tip over. To a accomplish the second function, the blow-by valve has a tip over protection switch (TOPS). smr2009-023-019_a NORMAL OPERATION Tip Over Protection Function If the watercraft tips over, gravity causes a valve piston to close and no engine oil will leak out of the blow-by valve. In this event, a pin (with magnet) opens a gap to the TOPS switch (Hall effect sensor) and the TOPS changes its state to "ON" and sends a sig- nal to the ECM.

The ECM will shut down the engine by cutting the ignition and the fuel injection. smr2009-023-018_a 1. Valve housing 2. Valve sleeve 3. Valve piston 4. Check ball 5. Valve pin (with magnet) 6. TOPS switch of the blow-by valve Blow-By Valve Operation Normal Operation During its normal operation, the blow-by valve al- lows crankcase vapors to return in the intake sys- tem where they are harmlessly burned. The TOPS switch TOPS state is "OFF", no signal to the ECM.

smr2009-023-020_a TIP OVER FUNCTION By-Pass Function If, for any reason, the valve piston gets stuck at normal operation and the crankcase pressure exceeds 40 kPa (6 PSI), the pressure unseats a check ball and crankcase vapors can bypass the valve piston. 108 smr2009-023