Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) NOTE: After voltage test, clear the fault codes in the ECM using the B.U.D.S. software. Blow-By Valve TOPS Switch Output Voltage Test Remove the blow-by valve. Back-probe TOPS connector and check voltage using the FLUKE 115 MULTIMETER (P/N 529 035 868) . NOTE: To easily probe wire terminals through the back of the connector, use the FLUKE RIGID BACK PROBES (P/N TP88) or an equivalent. smr2009-023-021_a BY-PASS FUNCTION Blow-By Valve TOPS Switch Input Voltage Test Remove: Deck extension, refer to BODY subsection Air intake silencer, refer to AIR INTAKE SYS- TEM subsection. Disconnect the TOPS switch connector of the blow-by valve.

Briefly press the START/STOP button to wake-up the ECM. Probe terminals as shown to check the voltage output from the ECM. smr2009-023-050_a BLOW-BY VALVE IN NORMAL POSITION 1. Blow-by valve 2. RED probe into pin 2 3. BLACK probe into pin 1 Replace TOPS switch if not within specification. Blow-By Valve TOPS Switch Circuit Continuity Test Disconnect the TOPS switch connector of the blow-by valve. Disconnect the connector A from the ECM. Use the ECM ADAPTER TOOL (P/N 529 036 166) and a multimeter. smr2009-023-103_a If voltage test is good, check the TOPS switch out- put voltage. If voltage test is not good, check the continuity of the blow-by valve TOPS switch circuit.

smr2009-023 109 TOPS SWITCH CONNECTOR BLOW-BY VALVE POSITION VOLTAGE Pin 1 and pin 2 Normal position 0.4 ± 0.1 Vdc Pin 1 and pin 2 Upside down 4.4 ± 0.2 Vdc Pin 2 and pin 3 Normal position or upside down Approximately 5 Vdc TOPS SWITCH CONNECTOR VOLTAGE Pins 2 and 3 Approximately 5 Vdc