Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) smr2009-023-051 529036166 When installing the TOPS switch, make sure printed information is visible. Check continuity of the blow-by valve TOPS switch circuit as per following table. smr2009-023-052_a 1. TOPS valve inscriptions Blow-By Valve Removal Remove: Deck extension, refer to BODY subsection Air intake silencer, refer to AIR INTAKE SYS- TEM subsection. Remove ventilation hose from blow-by valve. Remove the CPS connector from its support on blow-by valve. smr2009-023-103_b 1. Pin 1 2. Pin 2 3. Pin 3 If continuity test is good, check ECM. Refer to ELECTRONIC FUEL INJECTION (EFI) subsection.

If continuity test is not good, repair or replace de- fective wires or connectors. Blow-By Valve TOPS Switch Replacement Remove blow-by valve and turn it upside down. Insert a small screwdriver between TOPS switch and its retaining tab. Twist and hold the TOPS switch then release the other retaining tab. smr2009-023-013_a 1. Blow-by valve 2. CPS connector 110 smr2009-023 TOPS SWITCH CONNECTOR ECM ADAPTER RESISTANCE Pin 1 Pin F4 Close to 0 (continuity) Pin 2 Pin G1 Pin 3 Pin C4