Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) 1. O-rings smr2009-023-025_a 1. Oil cooler Oil Cooler Inspection If O-rings are brittle, cracked or hard, replace them. Clean both contact surfaces of oil cooler. Check and clean the oil inlet and outlet area for dirt and other contaminations. Oil Cooler Removal Remove engine from vehicle. Refer to ENGINE REMOVAL AND INSTALLATION subsection. Disconnect cooling hoses from oil cooler. Remove screws securing oil cooler. Oil Cooler Installation For installation, reverse the removal procedure. Pay attention to the following details. Apply engine oil on O-rings. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of oil cooler screws.
Tighten screws to 9 N•m (80 lbf• in ). smr2007-015-007_a 1. Oil cooler crews 2. Oil cooler Remove oil cooler from engine. Ensure not to lose O-rings located between oil cooler and engine. 112 smr2009-023