Section 02 ENGINE Subsection 09 (COOLING SYSTEM) GENERAL During assembly/installation, use torque values and service products as in the exploded view. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be replaced with new ones. smr2009-024-002_a 1. Bleed nipple 2. Coolant temperature sensor (CTS) Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards.
NOTICE Never modify cooling system ar- rangement, otherwise serious engine damage could occur. SYSTEM DESCRIPTION Technical Specifications A closed loop cooling system is utilized on the 1503 4-TEC engines, which offers an efficient engine cooling while keeping dirt and salt water out of the cooling system. This system keeps the temperature constant and prevents internal engine corrosion. A separate coolant expansion tank ensures that enough engine coolant is in the circuit during any operating condition. The coolant flow comes from the water pump im- peller into the cylinder block. It goes around the cylinders and straight up to the cylinder head.
A smaller quantity of engine coolant enters the cylin- der block on the exhaust side for a better cool- ing. In the cylinder head the water channels flow around the exhaust and then the intake valves and leave the engine through a large hose. From there the coolant goes back to the water pump hous- ing and depending on the engine temperature, it flows through the thermostat directly back to the water pump impeller, or it takes its way through the heat exchanger. Engine coolant is also directed towards the oil cooler (coolant type). Coolant temperature sensor and bleed nipple are located on the cylinder head.
MAINTENANCE ENGINE COOLANT WARNING To avoid potential burns, do not remove the expansion tank cap or loosen the ride plate drain plug if the engine is hot. Recommended Coolant Use BRP PREMIXED COOLANT (P/N 219 700 362) or a blend of 50% antifreeze with 50% demineral- ized water. NOTE: Using a blend of 40% antifreeze with 60% demineralized water will improve the cooling effi- ciency when watercraft is used in particularly hot weather and/or hot water condition. smr2009-024 117 TYPE Closed loop cooling system. COOLANT FLOW Flow from water pump. TEMPERATURE CONTROL Thermostat. SYSTEM BLEEDING Self-bleed type through expansion tank (hose at uppermost point of circuit).
MONITORING BEEPER Turns on at 100°C (212°F) on naturally aspirated engines. Turns on at 110°C (230°F) on supercharged engines.