Section 02 ENGINE Subsection 09 (COOLING SYSTEM) PROCEDURES PRESSURE CAP Pressure Cap Inspection Using a pressure cap tester, check pressure cap efficiency. If the efficiency is feeble, install a new 90 kPa (13 PSI) cap (do not exceed this pressure). CLAMPS Clamp Replacement To cut or secure Oetiker clamps of cooling system hoses, use the OETIKER PLIERS (P/N 295 000 070) . smr2009-024-004_a 1. Leak indicator hole TROUBLESHOOTING The following is provided to help in diagnosing the probable source of troubles. It is a guideline and it should not be assumed to list all possible prob- lems. Always check for fault codes. If a fault code is de- tected, service the fault code first.
Refer to MON- ITORING SYSTEM AND FAULT CODES subsec- tion. ENGINE OVERHEATING 1. Low coolant level. - Refill and check for leaks (coolant leaking out of engine leak indicator hole, hoses or clamps missing/defective, cylinder head gaskets leaks, ride plate leaking, etc.). Repair or replace. " 1. Cutting clamp 2. Securing clamp NOTE: Always check general condition of hoses and clamp tightness. 2. Air in cooling system - Refill and bleed cooling system. 3. Thermostat defective (does not open when en- gine gets hot) - Replace thermostat housing. 4. Water pump failure - Inspect and replace defective components. 5. Water temperature sensor defective - Check or replace.
Refer to ELECTRONIC FUEL INJECTION. 6. Ride plate or hoses damaged - Check or replace damaged components. 7. Exhaust system clogged - Flush exhaust system. 8. Internal passage blocked in cooling system - Inspect and clean. 120 smr2009-024