Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 09 (COOLING SYSTEM) INSPECTION COOLING SYSTEM LEAK TEST WARNING To avoid potential burns, do not remove the expansion tank cap or loosen the ride plate drain plug if the engine is hot. Remove the deck extension. Refer to BODY sub- section. Install the TEST CAP (P/N 529 035 991) on the coolant expansion tank. smo2009-002-137_a 1. Level between marks when engine is cold Do not install pressure cap at this time. Start engine and let run for a maximum of 2 min- utes. Stop engine and wait 15 minutes to cool down. Refill tank as necessary. NOTE: Properly cool exhaust system by installing a garden hose. Refer to EXHAUST SYSTEM sub- section.

Repeat this run-stop cycle 2 - 3 times until ther- mostat opens and stop engine. 529035991 NOTE: It is not necessary to install a hose pincher on overflow hose. Connect the VACUUM/PRESSURE PUMP (P/N 529 021 800) to test cap and pressurize system through coolant expansion tank to 90 kPa (13 PSI). smr2009-024-003_a 1. This hose becomes hot when thermostat opens Last, refill expansion tank and install pressure cap. When engine has completely cooled down, recheck coolant level coolant tank and top up if necessary. smr2009-024-103_a 1. Vacuum/pressure pump 2. Test cap Check all hoses, ride plate, engine and oil cooler for coolant leaks. Spray a soap/water solution and look for air bubbles.

Check the leak indicator hole if there is oil or coolant. If so, replace appropriate water pump shaft seal. smr2009-024 119