Section 02 ENGINE Subsection 09 (COOLING SYSTEM) Check if thermostat is in good condition. Refer to THERMOSTAT in this subsection. Water Pump Housing Leak Test Plug the connections of the oil cooler return hose, coolant tank hose, ride plate return hose and cylin- der head return hose with a rag. smr2009-024-006_a 1. Water pump housing 2. Cylinder head hose 3. Oil cooler inlet hose 4. Oil cooler outlet hose Remove water pump housing screws. 1. Oil cooler return connection 2. Coolant tank hose connection 3. Ride plate return hose connection 4. Cylinder head return hose connection Fill the water pump housing with water.
If a bigger quantity of coolant leaks out at the ride plate outlet connection, replace the water pump housing. If there is no leak, check the operation of the ther- mostat. Pull the water pump housing to remove it. smr2008-016-004_a Water Pump Housing Inspection Check if gasket is brittle, hard or damaged and re- place as necessary. Water Pump Housing Installation The installation is the opposite of the removal pro- cedure. However, pay attention to the following. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of water pump housing screws. Install screws as per the following illustration. 1. Water pump housing gasket 122 smr2009-024