Section 02 ENGINE Subsection 09 (COOLING SYSTEM) 6 1. Screws M6 x 25 2. Screws M6 x 105 1. Impeller NOTICE To prevent leaking, take care that the gaskets are exactly in groove when you rein- stall the water pump housing. NOTICE Coolant/oil pump shaft and impeller have left-hand threads. Remove by turning clockwise and install by turning counterclock- wise. Tighten screws to 9 N•m (80 lbf• in ) using the fol- lowing sequence. Water Pump Impeller Inspection Check impeller for cracks or other damage. Re- place impeller if damaged. Water Pump Impeller Installation The installation is the opposite of the removal pro- cedure. Pay attention to the following details.
NOTICE Be careful not to damage impeller wings during installation. Torque impeller to 3 N•m (27 lbf• in ). THERMOSTAT The thermostat is a single action type. WATER PUMP IMPELLER Thermostat Removal Remove the WATER PUMP HOUSING, see pro- cedure in this subsection. NOTE: The thermostat is located inside the water pump housing. Water Pump Impeller Removal Remove the WATER PUMP HOUSING, see pro- cedure in this subsection. Unscrew the impeller clockwise. Thermostat Test To check the operation of the thermostat, put it in water and heat water. Look inside the cylinder head return hose con- nection to see the movement of the thermostat.
Thermostat should open when water tempera- ture reaches 87°C (189°F). If there is no operation, replace the water pump housing. smr2009-024 123