Section 02 ENGINE Subsection 09 (COOLING SYSTEM) NOTE: Never use oil in the press fit area of the oil seal and rotary seal. Push water pump shaft oil seal in place by using thumb. Install the NEW rotary seal using a press and the WATER PUMP SEAL PUSHER (P/N 529 035 823) . 1. Pusher 2. Coolant/oil pump shaft 529035823 Remove rotary seal with a screwdriver. NOTICE Never use a hammer for the rotary seal or water/oil pump shaft installation. Only use a press to avoid damaging the ceramic component. NOTICE Be careful not to damage the surface of the rotary seal bore in PTO housing. Always replace also the oil seal behind the rotary seal. 1. Rotary seal 2.
Rotary seal installer Install the OIL SEAL GUIDE (P/N 529 035 822) on the end of coolant/oil pump shaft. 529035822 1. Oil seal Rotary Seal Installation The installation is the opposite of the removal pro- cedure. Pay attention to the following details. smr2009-024 125