Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 10 (CYLINDER HEAD) GENERAL WARNING Be careful to burns when working on a hot engine. NOTE: When diagnosing an engine problem, al- ways perform an engine leak test. This will help pin-point a problem. Refer to ENGINE LEAK TEST in this subsection for procedures. Always place the vehicle on level surface. Always disconnect the negative wire from the bat- tery before working on the engine. Even if the removal of many parts is not neces- sary to reach another part, it is recommended to remove these parts in order to check them. When disassembling parts that are duplicated in the engine, (e.g.:

valves, bushings), it is strongly recommended to note their position (cylinder 1, 2 or 3) and to keep them as a “group”. If you find a defective component, it would be much easier to find the cause of the failure within the group of parts (e.g.: you found a worn valve guide. A bent spring could be the cause and it would be easy to know which one among the springs is the cause to replace it if you grouped them at disassembly). Besides, since used parts have matched together during the engine operation, they will keep their matched fit when you reassemble them together within their “group”. During assembly/installation, use torque values and service products as in the exploded view.

Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. Preparation 1. Remove any required parts to give access to engine. 2. Remove safety lanyard. WARNING Safety lanyard must be removed to prevent engine to be cranked while fuel rail is re- moved to prevent fuel to be sprayed out. Fuel is flammable. 3. Remove jet pump (refer to JET PUMP subsec- tion). 4. Remove coolant pressure cap. WARNING To avoid potential burns, only remove the coolant pressure cap by wearing the appro- priate safety equipment. 5. Remove oil dipstick.

WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be replaced with new ones. Hoses, cable or locking ties removed during the removal must be reinstalled as per factory stan- dards. smr2009-025-002_a 1. Oil dipstick 6. Unplug and remove ignition coils. 7. Remove spark plugs. NOTE: Ignition coil may be used as an extractor. INSPECTION ENGINE LEAK TEST The procedure has to be done when engine oper- ating temperature of approximately 70°C (158°F) is reached. smr2009-025 129