Section 02 ENGINE Subsection 10 (CYLINDER HEAD) Leak Test Procedure NOTE: Cylinder numbers are molded on cylinder head cover. 1. Rotate engine crankshaft counterclockwise un- til the cylinder no. 1 is at Top Dead Center (TDC) compression stroke. 1.1 As the engine crankshaft is turned over, observe the movement of intake rocker arm of the cylinder to be checked. 1.2 After piston completes its cycle and the intake valve closes, observe the piston. 1.3 When it reaches its uppermost position this is TDC compression stroke . smr2009-025-003_a 1. Ignition coil 2. Spark plug 8. Remove cylinder head cover cowl. 9. Unscrew and remove cylinder head cover. 1. Intake rocker arms smr2009-025-004_a 1.
Cylinder head cover screw (8) 2. Secure the drive shaft adapter with a wrench lever against hull to prevent further crankshaft rotation. 3. Install gauge adapter from the ENGINE LEAK DOWN TEST KIT (P/N 529 035 661) into spark plug hole. 4. Connect to adequate air supply. NOTE: Each tester will have specific instruction on the gauge operation and required pressure. Refer to manufacturer's instructions. 5. Set needle of measuring gauge to zero. 6. Supply combustion chamber with air. 10. Install the DRIVE SHAFT ADAPTER (P/N 529 035 985) on drive shaft end. 529035985 11. To rotate engine crankshaft, use an appropri- ate wrench lever with drive shaft adapter. 130 smr2009-025