Section 02 ENGINE Subsection 10 (CYLINDER HEAD) 4. Rocker arm screw not properly tightened - Retighten screws with recommended torquing procedure. 4. Broken rocker arm(s) - Replace defective parts. 5. Faulty chain tensioner - Replace chain tensioner. PROCEDURES EXHAUST MANIFOLD 6. Chain guide is worn out - Replace chain guide. Exhaust Manifold Removal 1. Remove the moving deck. Refer to BODY sub- section. 2. Remove the air intake silencer. Refer to AIR IN- TAKE SYSTEM subsection. 3. Move muffler back. Refer to EXHAUST SYS- TEM subsection. 4. Unscrew the exhaust manifold beginning with the bottom screws. This will help holding the manifold while you remove the screws. 7.
Stretched timing chain or worn out sprocket - Replace timing chain and sprocket. 8. Camshaft is worn out - Check if camshaft radial clearance is out of spec- ification. OIL LEAKAGE FROM CYLINDER HEAD 1. Cylinder head cover gasket is leaking - Replace cylinder head cover gasket and retighten screws with recommended torque. - Check cylinder head cover for cracks or other damage. Replace if necessary. 2. Cylinder head cover screws are leaking - Replace cylinder head cover screws. 3. Spark plug tube gasket is leaking - Remove cylinder head cover and replace spark plug tube gasket. - Clean spark plug area from oil spillage. 4. Blow by valve is leaking - Replace blow by valve O-ring.
smr2008-017-002_a 1. Exhaust manifold screws 5. Camshaft sensor O-ring is leaking - Replace camshaft sensor O-ring. 5. Remove exhaust manifold. 6. Disconnect cooling hoses from exhaust mani- fold. 6. Cylinder head gasket is leaking - Remove cylinder head and check for damage. - Replace cylinder head gasket and retighten screws with recommended torquing procedure. Exhaust Manifold Inspection Inspect exhaust manifold condition paying atten- tion for cracks or other damage. Check contact surfaces and hose. Replace any defective part. Inspect plane surfaces for warpage. Small defor- mation can be corrected by grinding surface with a fine sand paper.
Install sand paper on a surface plate and rub part against oiled sand paper. ENGINE LACKS ACCELERATION OR POWER 1. Incorrect camshaft timing adjustment - Replace damaged components and readjust camshaft timing. 2. Intake or exhaust valves are leaking - Perform ENGINE LEAK TEST. - Check if valve seats properly in valve seat. - Repair or replace damaged components. Exhaust Manifold Installation NOTE: There is no gasket between cylinder block and exhaust manifold. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of exhaust manifold screws. 3. Broken valve spring(s) - Replace defective parts. 132 smr2009-025