Section 02 ENGINE Subsection 10 (CYLINDER HEAD) TYPICAL 1. Punch Check valve guide bore for abreased material. The inlet and exhaust valve guides have the same length and are interchangeable. NOTE: If valve guide has caused scoring during extraction, replace the cylinder head. Grease the bore in cylinder head and the leading end of valve guide with MOLYKOTE G-N (P/N 420 297 433) . TYPICAL A. Protrusion NOTE: After installing new guides, they must be reamed with a standard 6 mm reamer tool. These are available from various tool suppliers. Clean cylinder head carefully. Check that the valve seat is concentric with the new guide axis (check contact surface with engineer's blue). TYPICAL 1.
Valve guide leading end 2. Cylinder head bore 3. Jig With the VALVE GUIDE PUSHER (6 MM) (P/N 529 036 087) , press the valve guide into the COLD cylinder head as shown. smr2009-025 147 VALVE GUIDE PROTRUSION MINIMUM 12.4 mm (.4882 in) MAXIMUM 12.8 mm (.5039 in)