Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 10 (CYLINDER HEAD) VALVE GUIDES Valve Guide Replacement NOTICE Do not heat cylinder head for this procedure. NOTICE The sharp edge near the top of the valve guide must be machined away. Other- wise it will foul the valve guide hole in the cylinder head and destroy the cylinder head, as the valve guide is removed. Use a special reamer as far as the top of the notch. 1. Valve stem seal Apply engine oil on valve stem and install valve. NOTICE Be careful when valve stem is passed through sealing lips of valve stem seal. TYPICAL 1. Special reamer 2.

Notch Chase valve guide out of the cylinder head to- wards combustion chamber by using VALVE GUIDE REMOVER (6 MM) (P/N 529 036 086) . 1. Sealing lips of valve stem seal To ease installation of cotters, apply oil or grease on them so that they remain in place while relea- sing the spring. After springs are installed, ensure valve springs and valve spring retainer are properly locked by tapping on valve stem end with a soft hammer so that valve opens and closes a few times. NOTICE An improperly locked valve spring will cause engine damage. 146 smr2009-025