Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 10 (CYLINDER HEAD) % % % % % % ! A. Valve seat outer diameter INTAKE A. Valve face contact width B. Valve seat contact width Valve Seat Grinding NOTE: The valve seats may be reground with a valve seat grinder which centers on the valve guide. 1. Grind the valve seat at 45°. Remove no more material than absolutely necessary to clean the seat up. 2. Using a 35° stone, narrow the valve seat until the appropriate outer diameter is obtained. 3. Using a 55° stone for the intake and an 80° stone for the exhaust valve, reduce the valve seat contact width to the appropriate value mentioned above. 4.

Finally, coat the valve seating surface with a fine paste of valve grinding compound using a manual valve grinding mandrel. Lightly grind the valves until a smooth, even, uniform sealing surface of the appropriate inside and outside diameter is obtained on both the valve and the seat. Use only a hand held valve grinding mandrel with a suction cup, rotating the valve back and forth through about 45°, and then advancing the valve 45° before repeating this operation. % % % % Valve Installation For installation, reverse the removal procedure. Pay attention to the following details. Install NEW valve stem seal. % % A.

Valve seat outer diameter EXHAUST smr2009-025 145 VALVE SEAT OUTER DIAMETER Intake 37.35 mm (1.4705 in) Exhaust 30.3 mm (1.1929 in)