Section 02 ENGINE Subsection 10 (CYLINDER HEAD) Valve Face and Seat A. Valve stem diameter 1. Valve seat 2. Exhaust valve contaminated area 3. Valve face (contact surface to valve seat) Check valve face and seat for burning or pittings and replace valve or cylinder head if there are signs of damage. Ensure to seat valves properly. Apply some lap- ping compound on valve face and work valve on its seat with a lapping tool. Measure valve face contact width. NOTE: The location of contact area should be in center of valve seat. Measure valve seat width, using a caliper. Replace valve guide if it is out of specification or has other damages such as wear or friction sur- face.
Refer to valve guide replacement below. If valve seat contact width is too wide or has dark spots, replace the cylinder head. 144 smr2009-025 VALVE STEM DIAMETER NEW Exhaust 5.946 mm - 5.960 mm (.2341 in - .2346 in) Intake 5.961 mm - 5.975 mm (.2347 in - .2352 in) SERVICE LIMIT Exhaust 5.93 mm (.233 in) Intake VALVE SEAT CONTACT WIDTH NEW Exhaust 1.25 mm - 1.55 mm (.049 in - .061 in) Intake 1.10 mm - 1.30 mm (.043 in - .051 in) SERVICE LIMIT Exhaust 2 mm (.079 in) Intake 1.8 mm (.071 in) VALVE GUIDE INNER DIAMETER NEW Exhaust 5.994 mm - 6.018 mm (.236 in - .2369 in) Intake SERVICE LIMIT Exhaust 6.060 mm (.2386 in) Intake