Section 02 ENGINE Subsection 10 (CYLINDER HEAD) NOTE: Valve cotters must be properly engaged in valve stem grooves. 1. Position of the valve spring VALVES Valve Removal Remove valve spring. Push valve stem then pull valves out of valve guides. Valve Inspection Valve Stem Seal Inspection of valve stem seals is not needed because NEW seals should always be installed whenever cylinder head is removed. Valve Inspect valve surface, check for abnormal stem wear and bending. If so, replace by a new one. Valve Stem and Valve Guide Clearance Measure valve stem and valve guide in three places, using a micrometer and a small bore gauge. NOTE:
Clean valve guide to remove carbon de- posits before measuring. Change valve if valve stem is out of specification or has other damages such as wear or friction sur- face. 1. Intake valve 38 mm 2. Exhaust valve 31 mm Remove valve stem seal with a valve stem seal pliers such as the SNAP-ON VALVE STEM SEAL PLI- ERS (P/N YA8230) . smr2009-025 143