Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) GENERAL 3. Crankshaft or balancer shaft axial play out of specification - Measure crankshaft and balancer shaft axial play. - If axial play is out of specification, replace thrust washers. When disassembling parts that are duplicated in the engine, (e.g.: pistons, connecting rods etc.), it is strongly recommended to note their position (cylinder 1, 2 or 3) and to keep them as a “group”. If you find a defective component, it would be much easier to find the cause of the failure within the group of parts.

Besides, since used parts have matched together during the engine oper- ation, they will keep their matched fit when you reassemble them together within their “group”. During assembly/installation, use torque values and service products as in the exploded view. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. 4. Connecting rod axial play out of specification - Measure connecting rod axial play on crankshaft. - Replace connecting rod or crankshaft if out of specification. 5. Connecting rod screws got loose - Replace damaged components and retighten screws with the recommended torque.

BLUE SMOKE IN THE EXHAUST 1. Oil scrapper rings worn out - Replace piston rings. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be replaced with new ones. ENGINE SUDDENLY TURNS OFF (POOR IDLING) 1. Piston rings worn out - Replace piston rings. 2. Piston/cylinder wall clearance out of specifica- tion - Check piston/cylinder wall clearance. - Replace if out of specification. Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards. 3. Melted or broken piston - Check if oil spray nozzle is not clogged.

Refer to LUBRICATION SYSTEM subsection. - Replace piston and cylinder block if necessary. TROUBLESHOOTING The following is provided to help in diagnosing the probable source of troubles. It is a guideline and it should not be assumed to list all possible prob- lems. Always check for fault codes. If a fault code is de- tected, service the fault code first. Refer to EN- GINE MANAGEMENT section. PROCEDURES TIMING CHAIN Timing Chain Inspection Check timing chain on camshaft gear for exces- sive radial play. Check chain condition for wear and rollers condi- tion. UNUSUAL ENGINE NOISE OR VIBRATIONS 1. Heavy wear on plain bearings - Check radial play of plain bearings.

- Replace plain bearings if out of specification. 2. Crankshaft and balancer shaft are not properly aligned - Disassemble cylinder block and check if marks are properly aligned. 1. Timing chain If chain is excessively worn or damaged, replace it as a set (camshaft timing gear and timing chain). 152 smr2009-026