Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) Timing Chain Removal Remove: Engine oil (refer LUBRICATION SYSTEM sub- section) Engine from vehicle (refer to ENGINE RE- MOVAL AND INSTALLATION subsection) Cylinder head (refer to CYLINDER HEAD sub- section) PTO housing (refer to PTO HOUSING AND MAGNETO subsection) Crankshaft (refer to CRANKSHAFT in this sub- section) Timing chain. Timing Chain Installation The installation is essentially the reverse of the re- moval procedure but, pay attention to the follow- ing details. Ensure to perform proper valve timing. Lock crankshaft and camshaft at TDC (refer to CYLIN- DER HEAD subsection for the camshaft locking procedure).

Install chain, then install chain tensioner. 1. Plug screw 2. Gasket ring 3. Chain tensioner Chain Tensioner Inspection Check chain tensioner for excessive wear or cracks. Also check free movement of the chain tensioner piston. Chain Tensioner Installation The installation is essentially the reverse of the re- moval procedure but, pay attention to the follow- ing details. Torque chain tensioner plug screw to 17 N•m (150 lbf• in ). NOTICE Improper valve timing will damage engine components. CHAIN TENSIONER Chain Tensioner Removal NOTE: Removal of the intake manifold allows easier access to the chain tensioner, but is not necessary. Refer to INTAKE MANIFOLD subsec- tion. Remove:

Chain tensioner plug screw no. 18 with gasket ring no. 19 Chain tensioner no. 20 . PISTONS AND CONNECTING RODS Piston and Connecting Rod Removal 1. Disassemble CYLINDER BLOCK as per proce- dure in this subsection. NOTE: It is recommended to measure connecting rod big end axial play prior to remove connecting rod. Refer to INSPECTION below. 2. Remove connecting rod cap screws. smr2009-026 153