Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) 1. Connecting rod screws 1. Piston 2. Piston pin 3. Circlip NOTE: Before removing the connecting rod caps, mark them to remember the right position when reassembling. 3. Pull piston with connecting rod out of the cylin- ders. 4. Remove one piston circlip no. 8 and discard it. 6. Detach piston no. 10 from connecting rod no. 5 . Connecting Rod Inspection Connecting Rod Big End Axial Play Using a feeler gauge, measure distance between butting face of connecting rod and crankshaft counterweight. If the distance exceeds specified tolerance, replace the worn part. 1. Piston circlip NOTE:

The removal of both piston circlips is not necessary to remove piston pin. 5. Push piston pin no. 9 out of piston. 1. Crankshaft 2. Feeler gauge Connecting Rod Small End Radial Play Measure connecting rod small end. 154 smr2009-026 CONNECTING ROD BIG END AXIAL PLAY NEW 0.150 mm - 0.302 mm (.006 in - .012 in) SERVICE LIMIT 0.500 mm (.02 in)