Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) A. Connecting rod big end bearing 1. Bore gauge 2. Connecting rod If the connecting rod small end diameter is out of specification, replace small end bearing sleeve. NOTE: For small end bearing sleeve replacement contact a machine shop. After installing a NEW small end bearing sleeve on the connecting rod, the inner diameter and the oil holes need to be machined to specification. Measure piston pins (refer to PISTON PIN IN- SPECTION in this subsection). Compare to inside diameter of connecting rod to obtain connecting rod small end radial play. Use NEW bearings no. 12 , when connecting rod big end diameter is out of specification.

Piston Pin Inspection Using synthetic abrasive woven, clean piston pin from deposits. Inspect piston pin for scoring, cracking or other damages. Measure piston pin. See the following illustration for the proper measurement position. Connecting Rod Big End Radial Play Measure inside diameter of connecting rod big end. Compare to crankshaft pin. To measure the connecting rod big end diameter, use the OLD screws no. 11 . Install the OLD bearings no. 12 as they were mounted initially. Do the torque procedure as described below. A.

Piston pin diameter in the area of the bushing smr2009-026 155 CONNECTING ROD BIG END DIAMETER SERVICE LIMIT 45.080 mm (1.775 in) CONNECTING ROD BIG END RADIAL PLAY SERVICE LIMIT 0.09 mm (.0035 in) CONNECTING ROD SMALL END DIAMETER NEW 23.01 mm - 23.02 mm (.9059 in - .9063 in) SERVICE LIMIT 23.07 mm (.908 in) CONNECTING ROD SMALL END RADIAL PLAY SERVICE LIMIT 0.080 mm (.003 in)