Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) Measure connecting rod small end diameter (re- fer to CONNECTING RODS INSPECTION above) to check connecting rod small end radial play. Piston Inspection Inspect piston for scoring, cracking or other dam- ages. Replace piston and piston rings if neces- sary. Using a micrometer, measure piston at 18 mm (.709 in) perpendicularly (90°) to piston pin axis. 1. Micrometer set to the piston dimension NOTE: Make sure used piston is not worn. With the micrometer set to the dimension, adjust a cylinder bore gauge to the micrometer dimen- sion and set the indicator to 0 (zero). 1. Measuring perpendicularly (90°) to piston pin axis A. 18 mm (.709 in) 1.
Use the micrometer to set the cylinder bore gauge 2. Dial bore gauge The measured dimension should be as described in the subsequent table. If not, replace piston. Piston/Cylinder Wall Clearance Adjust and lock a micrometer to the piston dimen- sion. TYPICAL 1. Indicator set to 0 (zero) 156 smr2009-026 PISTON PIN DIAMETER NEW 22.996 mm - 23.000 mm (.905 in - .906 in) SERVICE LIMIT 22.990 mm (.905 in) PISTON MEASUREMENT NEW NOMINAL 99.931 mm - 99.949 mm (3.934 in - 3.935 in) SERVICE LIMIT 99.90 mm (3.933 in)