Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) NOTE: Make sure the cylinder bore gauge indica- tor is set exactly at the same position as with the micrometer, otherwise the reading will be false. Position the dial bore gauge 62 mm (2.44 in) above cylinder base, measuring perpendicularly (90°) to piston pin axis. Read the measurement on the cylinder bore gauge. The result is the exact piston/cylinder wall clearance. 1. Sleeve with piston circlip inside 2. Assembly jig from piston clip installer If clearance exceeds specified tolerance, re-hone cylinder sleeve and replace piston by an oversize one. NOTE:

It is not necessary to have all pistons replaced with an oversize if they are not all out of specification. Mixed standard size and oversize piston are allowed. Piston and Connecting Rod Assembly For installation, reverse the removal procedure. Pay attention to the following details. Apply engine oil on the piston pin. Insert piston pin into piston and connecting rod. Use the PISTON CIRCLIP INSTALLER (P/N 529 035 765) to assemble the piston circlip. CORRECT POSITION OF THE PISTON CIRCLIP Piston and Connecting Rod Installation 1. Using a piston ring compressor such as the SNAP-ON PISTON RING COMPRESSOR PLIERS (P/N RC980) , slide piston into cylinder.

529035765 NOTICE Secure piston pin with new piston circlips. NOTE: Take care that the hook of the piston circlip is positioned properly. NOTICE Install piston with punched arrow to- ward exhaust side. smr2009-026 157 PISTON/CYLINDER CLEARANCE NEW NOMINAL 0.044 mm - 0.076 mm (.0017 in - .003 in) SERVICE LIMIT 0.090 mm (.004 in)