Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) NOTE: Before removing the connecting rod caps, mark them to remember the right position when reassembling. It is recommended to measure connecting rod big end axial play prior to re- move connecting rod. Refer to PISTONS AND CONNECTING RODS in this subsection for the procedure. ENGINE UPSIDE DOWN 1. Oil reservoir plug screw with O-ring 10. Remove cylinder block screws no. 3 and no. 7 . 1. Mark on connecting rod 13. Remove thrust washers no. 4 . BOTTOM VIEW OF ENGINE 1. Screws 11. Remove cylinder block lower half. 12. Remove connecting rod screws. 1. Thrust washer 14. Remove crankshaft no. 5 . 1. Connecting rod screws smr2009-026 161