Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) Remove: Intake manifold (refer to INTAKE MANIFOLD subsection) Spark plugs Cylinder head cover (refer to CYLINDER HEAD subsection Crankshaft access plug screw. smr2009-026-004_a 1. Position lines Use a small screwdriver to check if the groove in the crankshaft is aligned with the hole. In this position, lock the crankshaft using the CRANKSHAFT LOCKING TOOL (P/N 529 035 821) . smr2009-026-002_a 1. Crankshaft access plug screw 2. Gasket ring Turn engine counterclockwise. Bring piston of cylinder no. 3 to ignition TDC, us- ing a dial gauge or another similarly suitable tool. Crankshaft Removal 1.

Drain engine oil (refer to LUBRICATION SYS- TEM subsection). 2. Remove engine from vehicle (refer to ENGINE REMOVAL/INSTALLATION subsection). 3. Remove cylinder head (refer to CYLINDER HEAD subsection). 4. Remove PTO housing (refer to PTO HOUSING AND MAGNETO subsection). 5. Remove starter gear (refer to PTO HOUSING AND MAGNETO subsection). 6. Remove starter drive. 7. Remove oil suction pump (refer to LUBRICA- TION SYSTEM subsection). 8. Remove engine mounting brackets. 9. Remove oil reservoir plug screws no. 1 with O-ring no. 2 . 529035821 NOTICE Do not scratch or damage piston and cylinder surface. smr2009-026-003_a 1. Dial gauge NOTE: When the piston of cylinder no.

3 is at igni- tion TDC, the position lines on oil separator cover must be lined up as shown in the following illus- tration. 160 smr2009-026