Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) 1. Rectangular ring 2. Taper-face ring 3. Oil scraper ring & NOTICE Ensure that top and second rings are not interchanged. 1. Piston 2. Filler gauge Ring End Gap NOTE: Use a ring expander to prevent breakage during installation. The oil ring must be installed by hand. Check that rings rotate smoothly after installation. Space the piston ring end gaps 120° apart and do not align the gaps with the piston pin bore or the thrust side axis. A A A Measure position for ring end gap in the area of 8 mm to 16 mm (.315 in to .63 in) from top of cylinder. NOTE: In order to correctly position the ring in the cylinder, use piston as a pusher.
Using a feeler gauge, check ring end gap. Replace ring if gap exceeds above described specified tol- erance. 1 2 Piston Ring Installation For installation, reverse the removal procedure. Pay attention to the following details. Install the oil scraper ring first, then the taper-face ring with the word “TO” facing up, then the rect- angular ring with the word facing up. A31C2OA 1. DO NOT align ring gap with piston trust side axis 2. DO NOT align ring gap with piston pin bore axis A. 120° CRANKSHAFT Crankshaft Locking Procedure NOTICE The crankshaft must be locked at TDC for removal and installation of crankshaft, balancer shaft and camshaft. NOTE:
When the crankshaft is locked, the piston of cylinder no. 3 is at ignition TDC. smr2009-026 159 RING END GAP NEW RECTANGULAR 0.35 mm - 0.50 mm (.014 in - .02 in) TAPER-FACE OIL SCRAPER RING SERVICE LIMIT ALL 1.0 mm (.04 in)