Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) Crankshaft Axial Clearance When assembling the cylinder-block, measure the crankshaft axial clearance. 1. Mark on balancer shaft 2. Mark on crankshaft For correct installation of the connecting rods, re- fer to PISTONS AND CONNECTING RODS in this subsection. NOTICE It is absolutely necessary to follow this procedure. Otherwise severe engine dam- age can occur. 1. Dial gauge 2. Crankshaft Insert thrust washers no. 4 as soon as crankshaft is in place as per following illustration. NOTICE Never forget thrust washers on cen- ter of crankshaft to control axial adjustment. Crankshaft Installation For installation, reverse the removal procedure.

Pay attention to following details. NOTE: Before installing the crankshaft, make sure that the timing chain is on the crankshaft and the chain guide has been installed first. Those parts cannot be installed when the crankshaft is in place. NOTICE Crankshaft and balancer shaft marks have to be aligned. THRUST WASHER INSERT DIRECTION 1. Thrust washer NOTICE Thrust washers have to be flush with the cylinder block sealing surface. smr2009-026 163 CRANKSHAFT PIN RADIAL CLEARANCE SERVICE LIMIT 0.09 mm (.0035 in) CRANKSHAFT AXIAL CLEARANCE NEW 0.08 mm - 0.22 mm (.003 in - .009 in) SERVICE LIMIT 0.35 mm (.014 in)