Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) 1. Thrust washer 2. Sealing surface 1. Crankshaft locking tool Install cylinder block lower half. Refer to CYLIN- DER BLOCK in this subsection. Install the crankshaft cover before mounting the engine bracket. Apply engine oil on O-ring and press cover in. Crankshaft cover has to be flush with cylinder block surface. BALANCER SHAFT Balancer Shaft Removal 1. Drain engine oil (refer to LUBRICATION SYS- TEM subsection). 2. Remove engine from vehicle (refer to ENGINE REMOVAL AND INSTALLATION subsection). 3. Remove cylinder head (refer to CYLINDER HEAD subsection). 4. Remove PTO housing (refer to PTO HOUSING AND MAGNETO subsection). 5.

Remove starter gear (refer to PTO HOUSING AND MAGNETO subsection). 6. Remove starter drive. 7. Remove oil suction pump (refer to LUBRICA- TION SYSTEM subsection). 8. Remove engine mounting brackets. 9. Remove oil reservoir plug screws no. 1 with O-ring no. 2 . 1. O-ring 2. Crankshaft cover Install the CRANKSHAFT LOCKING TOOL (P/N 529 035 821) right away to position crankshaft at TDC before installing the camshaft and the rocker arms (refer to CYLINDER HEAD subsection). 529035821 ENGINE UPSIDE DOWN 1. Oil reservoir plug screw with O-ring 10. Remove cylinder block screws no. 3 . 164 smr2009-026