Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) 1. Screws 11. Remove cylinder block lower half. 12. Remove thrust washers no. 6 . 1. Micrometer 2. Balancer shaft area for bearing Balancer Shaft Axial Clearance When assembling the cylinder-block, measure the balance shaft axial play. 1. Thrust washer 13. Remove balancer shaft. Balancer Shaft Inspection Check balancer shaft and replace if damaged. If the gear on the balancer shaft is damaged, re- place balancer shaft. Check gear on the crankshaft at the same time and replace crankshaft if necessary (refer to CRANKSHAFT above). Balancer Shaft Bearing Seat Play Measure all balancer shaft bearing seats.
Com- pare to inside diameter of balancer shaft bearings (elsewhere in this subsection). 1. Dial gauge 2. Balancer shaft smr2009-026 165 BALANCER SHAFT SEAT DIAMETER NEW 31.984 mm - 32.000 mm (1.2592 in - 1.2598 in) SERVICE LIMIT 31.960 mm (1.2583 in) BALANCER SHAFT SEAT RADIAL CLEARANCE SERVICE LIMIT 0.07 mm (.0028 in) BALANCER SHAFT AXIAL CLEARANCE NEW 0.02 mm - 0.25 mm (.001 in - .01 in) SERVICE LIMIT 0.35 mm (.014 in)