Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) Balancer Shaft Installation For installation, reverse the removal procedure. Pay attention to following details. NOTICE Balancer shaft and crankshaft marks have to be aligned. 1. Thrust washer 2. Sealing surface Install cylinder block lower half. Refer to CYLIN- DER BLOCK in this subsection. Install the crankshaft cover before mounting the engine bracket. Apply engine oil on O-ring and press cover in. Crankshaft cover has to be flush with cylinder block surface. 1. Mark on balancer shaft 2. Mark on crankshaft NOTICE Never forget thrust washers no. 6 on PTO side to control axial adjustment on bal- ancer.
Insert thrust washers as soon as balancer shaft is in place as per following illustration. 1. O-ring 2. Crankshaft cover Install the CRANKSHAFT LOCKING TOOL (P/N 529 035 821) right away to position crankshaft at TDC before installing the camshaft and the rocker arms (refer to CYLINDER HEAD subsection). THRUST WASHER INSERT DIRECTION 1. Thrust washer NOTICE Thrust washers have to be flush with the cylinder block sealing surface. 529035821 166 smr2009-026