Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) 1. Crankshaft locking tool 1. Mark on balancer shaft bearings 2. Mark on crankshaft bearings CYLINDER BLOCK Cylinder Block Disassembly Remove:
Engine oil (refer to LUBRICATION SYSTEM subsection) Engine from vehicle (refer to ENGINE RE- MOVAL AND INSTALLATION subsection) Cylinder head (refer to CYLINDER HEAD sub- section) PTO housing (refer to PTO HOUSING AND MAGNETO subsection) Starter gear and starter drive (refer to PTO HOUSING AND MAGNETO subsection) Oil suction pump (refer to LUBRICATION SYS- TEM subsection) Balancer shaft (refer to BALANCER SHAFT elsewhere in this subsection) Crankshaft (refer to CRANKSHAFT elsewhere in this subsection) Piston with connecting rod (refer to PISTONS AND CONNECTING RODS elsewhere in this subsection). Starter Drive Bearing Check bearing no. 21 of starter drive assembly no.
22 in cylinder block and replace it if damaged. TYPICAL 1. Bearing of starter drive assembly Bearings When bearings need to be removed from the cylinder block, mark them to identify the correct position at installation. See the following illustra- tion for an example: Starter drive bearing can be easily removed from crankcase lower half using the a small slide ham- mer such as the SNAP-ON SMALL SLIDE HAMMER (P/N CJ93B) . '( smr2009-026 167