Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) Close puller claws so that they can be inserted in end bearing. Holding claws, turn puller shaft clockwise so that claws open and become firmly tight against bearing. Slide puller hammer outwards and tap puller end. Retighten claws as necessary to always maintain them tight against bearing. Continue this way un- til bearing completely comes out. Cylinder Out of Round Measure cylinder diameter in piston axis direction from top of cylinder. Take an other measurement 90° from first one and compare. NOTE: Take the same measuring points as de- scribed in CYLINDER TAPER above.
Cylinder Block Inspection Cylinder Check cylinder for cracks, scoring and wear ridges on the top and bottom of the cylinder. If so, re- place cylinder. Cylinder Taper Measure cylinder bore and if it is out of specifica- tions, re-hone cylinder sleeve and replace piston with first oversize. NOTE: It is not necessary to have all cylinders re-honed if they are not all out of specification. Mixed standard size and oversize cylinders are allowed. Measure cylinder bore at 3 recommended posi- tions. See the following illustration. A. Perpendicular to crankshaft axis B. Parallel to crankshaft axis Bearings To measure the wear of the crankshaft bearings no. 13 and no.
14 and balancer shaft bearings no. 15 , both cylinder block halves with OLD bearings have to be screwed together as per tightening procedure described below. Measure the inside diameter of the bearings with a bore gauge. 1. First measuring diameter 2. Second measuring diameter 3. Third measuring diameter A. 60 mm (2.362 in) B. 110 mm (4.331 in) Distance between measurements should not ex- ceed the service limit mentioned above. ENGINE UPSIDE DOWN 1. Bore gauge 168 smr2009-026 CYLINDER OUT OF ROUND NEW MAXIMUM 0.008 mm (.0003 in) SERVICE LIMIT 0.015 mm (.0006 in) CYLINDER TAPER IN DIAMETER NEW MAXIMUM 0.038 mm (.001 in) SERVICE LIMIT 0.090 mm (.004 in)