Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) Correctly install bearings. Top crankshaft bearing halves have a bore which has to be placed in the upper cylinder block. 1. Cylinder block upper half 2. Oil bore in cylinder block 3. Oil bore in bearing ENGINE UPSIDE DOWN 1. Bore gauge Bearings have to be flush with the cylinder block split surface and their protrusions have to fit in the notched areas in the cylinder block seat. Replace bearings if they are out of specifications. Cylinder Block Assembly For assembly, reverse the disassembly proce- dure. Pay attention to the following details. Torque Banjo screw to 19 N•m (168 lbf• in ). To install starter drive bearing no.
21 of starter drive assembly, use the STARTER DRIVE SEAL PUSHER (P/N 420 876 502) and the HANDLE (P/N 420 877 650) . 420876502 1. Bearing protrusion in cylinder block notch Apply engine oil on all bearings, in the bottom area of the cylinder bore and also on the band of the piston ring compressor tool. For proper installation of pistons, refer to PIS- TONS AND CONNECTING RODS in this subsec- tion. NOTE: Before installing the crankshaft, make sure that the timing chain is on the crankshaft and the chain guide has been installed first. Those parts cannot be installed after as the crankshaft is in place. 420877650 Use NEW bearings when diameters are out of specification.
If OLD bearings can be used again, make sure they are at the same position as they were before. smr2009-026 169 CRANKSHAFT BEARING INSIDE DIAMETER SERVICE LIMIT 50.1 mm (1.9724 in) BALANCER SHAFT BEARING INSIDE DIAMETER SERVICE LIMIT 32.11 mm (1.2642 in)