Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 11 (CYLINDER BLOCK) Clean oil passages and make sure they are not clogged. Clean all metal components in a solvent. Cylinder block mating surfaces are best cleaned using a combination of the LOCTITE CHISEL (GAS- KET REMOVER) (P/N 413 708 500) and a brass brush. Brush a first pass in one direction then make the fi- nal brushing perpendicularly (90°) to the first pass (cross hatch). NOTICE Do not wipe with rags. Use a new clean hand towel only. IMPORTANT: When beginning the application of the crankcase sealant, the assembly and the first torquing should be done within 10 minutes. It is suggested to have all you need on hand to save time. NOTE:

It is recommended to apply this specific sealant as described here to get an uniform appli- cation without lumps. If you do not use the roller method, you may use your finger to uniformly dis- tribute this sealant. Apply LOCTITE 5910 (P/N 293 800 081) on mating surfaces. Do not apply in excess as it will spread out inside crankcase. Tighten cylinder block screws as per following pro- cedure: Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on screw threads. Torque cylinder block screws no. 3 to 40 N•m (30 lbf•ft) following sequence 1 to 8 and then to 55 N•m (41 lbf•ft) (repeat sequence). Torque cylinder block screws no. 7 to 23 N•m (17 lbf•ft) following sequence 9 to 23.

NOTICE Do not use other products to seal crankcase. Do not use an activator with the Loctite 5910. Using other products or non sil- icone-based sealant over a previously sealed crankcase with Loctite 5910 will lead to poor adhesion and possibly a leaking crankcase. NOTE: Refer to the product label for the sealant curing time. Respect the manufacturer's recom- mendations prior to start engine. Use a plexiglass plate and apply some sealant on it. Use a soft rubber roller of 50 mm - 75 mm (2 in - 3 in) available in arts products suppliers for printmaking, roll the sealant to get a thin uniform coat on the plate (spread as necessary). When ready, apply the sealant on crankcase mating surfaces.

NOTE: Before continuing the assembly process, the axial clearance of balancer shaft and crank- shaft has to be checked. Refer to CRANKSHAFT and BALANCER SHAFT in this subsection for the procedure. 170 smr2009-026