Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 03 (COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE) COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE SERVICE TOOLS Description Part Number Page MPI-2 DIAGNOSTIC CABLE.......................................................... 710 000 851 ......................................... 182 MPI-2 INTERFACE CARD.............................................................. 529 036 018 ......................................... 182 SERVICE TOOLS OTHER SUPPLIER Description Part Number Page MALE-FEMALE EXTENSION SERIAL CABLE............................... DB9 .........................................

182 GENERAL Refer to PROCEDURES for instructions on the communication tools. If communication problems occurs, refer to TROUBLESHOOTING. NOTE: Never use the D.E.S.S. POST INTERFACE. vdd2006-001-151_b Prerequisite for USB communication: PC Computer turned on. MPI-2 connected to PC computer. 529036019_a TROUBLESHOOTING Prerequisite for CAN communication: MPI-2 connected to diagnostic connector of ve- hicle. ECM turned on (press the START button). D.E.S.S. key installed on D.E.S.S. post of vehi- cle. B.U.D.S. started and logged. DIAGNOSTIC TIPS IMPORTANT: Make sure all connections have been made before starting B.U.D.S. to allow proper operation.

MPI-2 Connection Troubleshooting MPI-2 Status Lights The MPI-2 includes 2 status lights to show the connection conditions: USB and CAN. Both lights must be GREEN so that MPI-2 works properly. Otherwise, refer to the following charts. smr2009-028 179 USB LIGHT STATUS WHAT TO DO Light is OFF Check USB connection between MPI-2 and PC computer. Check USB operation on PC computer (hardware or Windows drivers). Light is GREEN Connections are GOOD. Communication can take place on USB side.