Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 03 (COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE) Message Box: "No Vehicle Detected..." If the following message box is displayed in B.U.D.S.: Communication Problems with B.U.D.S. smr2008-020-003 Missing Module If an “X” is shown in the status bar, it means that no "ECU" is communicating with the MPI. 1. Ensure both USB and CAN lights of MPI-2 are GREEN. Refer to MPI-2 CONNECTION TROU- BLESHOOTING subsection. 2. Check MPI-2 protocol. It must be set to Kw2000 (500K) . mmr2009-020-001 Check the following: MPI protocol in B.U.D.S. Connections between the PC computer and the vehicle.
If one or more “ECU” is (are) not communicating with the MPI a module may not be powered or is defective. Check to find which module is missing in B.U.D.S. The tab of the missing module will not be visible at the bottom of B.U.D.S. screen. rmr2008-020-003_en Ensure the status bar shows the Kw2000 500K and the number 4 to its right. Otherwise, refer to MPI-2 CONNECTION TROUBLESHOOTING in this subsection. rmr2008-058-100 CONNECTION SUCCESSFUL Number 4 means that 4 are connected: ECM Information center iBR iS. smr2009-028-001_a 1. iS tab not visible meaning this "ECU" is not communicating If a module is missing, check wiring and power supply to that module.
180 smr2009-028 CAN LIGHT STATUS WHAT TO DO Light is OFF Check connection between MPI-2 and diagnostic connector of vehicle. Light is RED Check CAN wires/connectors on vehicle. Light is GREEN Connections are GOOD. Communication can take place on CAN side.