Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 03 (COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE) Message Box: "Some of the Information Normally Displayed..." If the following message box is displayed in B.U.D.S.: NOTE: Never use the D.E.S.S. POST INTERFACE. smr2009-028-016 1. Click on the OK button in B.U.D.S. 2. Remove and reinstall the D.E.S.S. key to make a good contact with its post. 3. Briefly press the vehicle START button to acti- vate the ECM. Do not hold START button to avoid engine starting . 4. Click on the Read button in B.U.D.S. 529036019_a Connections with Vehicle Open the aft re-boarding platform. Message Box:
"Engine must be Stopped..." If the following message box is displayed in B.U.D.S.: smr2009-028-015 1. Click on the Cancel button in B.U.D.S. 2. Briefly press the vehicle START button to acti- vate the ECM. Do not hold START button to avoid engine starting . 3. Click on the Write button in B.U.D.S. If message reappears, do the following: 1. Click on the Cancel button in B.U.D.S. 2. Remove the D.E.S.S. key. 3. Press the vehicle START button to activate the ECM. 4. Reinstall the D.E.S.S. key and make sure it has a proper contact with its post. 5. Click on the Write button in B.U.D.S. ssi2009-002-002_a 1. Re-boarding platform Remove the starboard storage bin. ssi2009-002-003_a 1.
Starboard storage bin PROCEDURES MPI-2 Disconnect the 6-pin diagnostic connector. The MPI-2 (Multi-Purpose Interface-2) in conjunc- tion with the MPI-2 diagnostic cable is used with B.U.D.S. software to communicate with the ECM (engine control module) and other modules. smr2009-028 181