Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) Beeper Signals When one of the below conditions occurs, the monitoring system emits the following beep sig- nals. FAULT CODES A fault code is an indication that a glitch or mal- function is detected by the monitoring system of the vehicle. A fault code consists of a letter followed by a num- ber with 4 digits. The letter defines the type of fault code while the number refers to a unique fault. Verify if the check engine light is ON. If so, look for fault codes to diagnose the trouble.

The fault codes recorded in the related module can be checked on the information center or by using the software B.U.D.S. NOTE: Many fault codes at the same time is likely to be burnt fuse(s) or a bus bar connection in fuse box(es). For more information pertaining to the fault codes (state, count, first, etc.) and report, refer to B.U.D.S. online help. When the fault is not active anymore, its status is changed from active to occurred and it is stored in the related module. Stored fault codes are kept in the module even if the battery is disconnected. When using the service action suggested in the Fault section of B.U.D.S., the system circuits are referred as A-M4 for instance.

It means ECM con- nector “A” and the circuit wire M4 as found in the WIRING DIAGRAM. IMPORTANT: After a problem has been solved, ensure to clear the fault(s) in the related mod- ule. Refer to CLEARING FAULT CODES USING B.U.D.S. SOFTWARE in this subsection. 190 smr2009-029 BEEPER CODES DESCRIPTION Continuously beeps High engine temperature coolant. Refer to COOLING SYSTEM subsection. High exhaust temperature. Refer to ELECTRONIC FUEL INJECTION. Low oil pressure. Turn off engine as soon as possible. Check oil level and refill. Refer to LUBRICATION subsection. BEEPER CODES DESCRIPTION 1 long beep (while installing D.E.S.S. key on watercraft post if ECM is on) Bad D.E.S.S. system connection.

Reinstall D.E.S.S. key correctly over post. Wrong D.E.S.S. key. Use a D.E.S.S. key that has been programmed for the watercraft. Defective D.E.S.S. key. Use another programmed D.E.S.S. key. Dried salt water in D.E.S.S. key. Clean D.E.S.S. key with fresh water to remove salt water. Defective D.E.S.S. post. Check. Refer to DIGITALLY ENCODED SECURITY SYSTEM subsection. Improper operation of ECM or defective wiring harness. Check. Refer to ELECTRONIC FUEL INJECTION subsection. A 2 seconds beep every 15 minutes interval Watercraft is upside down. Turn watercraft upright. TOPS switch is disconnected of defective. Check. Refer to LUBRICATION subsection. Engine management system fault.

Read the fault code. A 2 seconds beep every 5 minutes interval Low fuel level. Refill fuel tank. If problem persists, check sensor and circuit. Refer to FUEL TANK AND FUEL PUMP. Fuel tank level sensor or circuit malfunction. Check sensor and circuit. Refer to FUEL TANK AND FUEL PUMP.