Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) Fault Code Types There are 4 types of fault codes used on the vehi- cle: for information center and switches faults (Bxxxx) for iBR and iS faults (Cxxxx) for power train faults (Pxxxx) for CAN communication faults (Uxxxx). There are 4 modules that stores the fault codes: ECM (Engine Control Module) iBR (Intelligent Brake and Reverse) Cluster (Information Center) iS (Intelligent Suspension) The ECM stores mainly “P” codes and some “U” codes. The iBR stores mainly codes and a few codes. The Cluster mainly codes and a few codes. The iS stores mainly codes and a few codes.

smo2009-002-114_w FAULT CODE DISPLAY FUNCTION Fault Code Reading on the Information Center NOTE: Only active faults will be displayed. Press the MODE button repeatedly until the FAULT CODE function is visible in the multifunc- tion display. Press the SET button or the UP or DOWN arrow button to enter the function and display the first fault code, then press the UP or DOWN arrow but- ton repeatedly to display each subsequent code. NOTE: When the last fault code has been dis- played and the button is pressed again, the system loops back to the first fault code dis- played, and all fault codes can again be displayed.

If there was one active fault code when entering the FAULT CODE mode, and it becomes occurred (no longer active), a NO ACTIVE FAULT CODE message will scroll in the display. To exit the FAULT CODE display function, the MODE or SET button must be pressed once. There is no time out on this function. smo2009-002-114_x TYPICAL - ENGINE FAULT CODE EXAMPLE Fault Code Reading Using B.U.D.S. Software Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE section. Clearing Fault Codes using B.U.D.S. Software The fault(s) (occurred state) can be cleared by pressing the shown button in B.U.D.S. NOTE: An active fault code cannot be cleared.

In other words, the problem must be repaired before clearing the fault. rmr2008-039-009 FAULTS TAB, ALL FAULTS smr2009-029 191