Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) This will reset the appropriate counter(s) and will also record that the problem has been fixed in the related module memory. Fault Code U0129 CAN communication error between ECM and iBR modules or iBR CAN message timeout or validity. This fault may occasionally appear as occurred. Normal operation is not affected. If it the count is high, check the related components. SPECIFIC FAULT CODES Several Fault Codes are Active at once If this occurs, check the following: Check the 30 A fuses in fuse box 2. Check the bus bar condition and connections in fuse box(es).
Check the diagnostic connector for the pres- ence of water or corrosion. Check the CAN wires. Fault Code P0562 Battery voltage too low. It occurs when both bat- tery voltage and engine RPM conditions are met. See chart. Fault Code C2121, C2221 iBR or iS application parameters corrupted (backup no. 1 or no. 2). This fault may occa- sionally appear as occurred. It happens when power to the module is cut before the module normally completed its shutdown. Normal op- eration is not affected. If it occurs often, check supply voltage to module. Fault Code P0563 Battery voltage too high. It occurs when battery voltage is above 16 Vdc when engine is running. Refer to CHARGING SYSTEM.
Fault Code U016A Loss of vehicle speed. This fault may occasion- ally appear as occurred. Normal operation is not affected. If it the count is high, check the related components. Fault Code C2122, C2222 iBR or iS last session interrupted. This fault may occasionally appear as occurred. It occurs when power to the module is cut before the module nor- mally completed its shutdown. Normal operation is not affected. Fault Code U0300 Incorrect ECM or information center for the en- gine. Installed part is not appropriate for the ve- hicle. Engine will crank but will not start . Refer to PARTS CATALOGS for proper part according to vehicle.
Fault Code C2130, C2150, C2233, C2250 iBR or iS motor or system current software breaker. Motor or module current too high. This fault may occasionally appear as occurred. Nor- mal operation is not affected. If it the count is high, check the moving mechanism of the system if it is stiffer than normal to operate. Fault Code U16A1, U16A2, U16A3, U16A4, U16A5 Cluster or iBR CAN timeout error-missing CAN ID xxxh. This fault may occasionally appear as oc- curred. Normal operation is not affected. If it the count is high, check the related components. Fault Code C2232 Motor open.
If suspension operates when using the Up/Down s, the suspension will operate nor- mally when riding even if this fault is active. In this case, the fault can be ignored. The fault will be set to "occurred" when the iS module will be shut down. If suspension does not operate when using the Up/Down s, refer to SUSPENSION (iS) subsection. Fault Code U401, U0457 ECM or cluster CAN message timeout or validity. This fault may occasionally appear as occurred. Normal operation is not affected. If it the count is high, check the related components. 192 smr2009-029 BATTERY VOLTAGE ENGINE SPEED Lower than 6.5 Vdc Lower than 1280 RPM Lower than 11.8 Vdc Greater than 1280 RPM