Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) FAULT CODE TABLE smr2009-029 193 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION B2210 Cluster Left keypad fault (switch kept activated more than 60 seconds) Problem with left keypad The switch may be defective, verify the functionality of the switch or the wires. Refer to the Shop Manual for switch diagnosis/testing procedure. B2211 Cluster Suspension UP/ DOWN switches shorted to ground fault Problem with left keypad Look for pin B if shorted to ground or pin C.

B2212 Cluster Suspension UP/ DOWN switches disconnected fault Problem with left keypad Look for pin B if disconnected to pin 14 on the cluster. Look for pin C if disconnected to pin 15 on the cluster. B2213 Cluster VTS UP/DOWN switches shorted to ground fault Problem with left keypad Look for pin A if shorted to ground or pin C. B2214 Cluster VTS UP/DOWN switches disconnected fault Problem with left keypad Look for pin A if disconnected to pin 13 on the cluster. Look for pin C if disconnected to pin 15 on the cluster.

B2220 Cluster Right keypad fault (switch kept activated more than 60 seconds) Problem with right keypad The switch may be defective, verify the functionality of the switch or the wires. Refer to the Shop Manual for switch diagnosis/testing procedure. B2221 Cluster MODE/SET switches shorted to ground fault Problem with right keypad Look for pin B if shorted to ground or pin C. B2222 Cluster MODE/SET switches disconnected fault Problem with right keypad Look for pin B if disconnected to pin 17 on the cluster. Look for pin C if disconnected to pin 18 on the cluster. B2223 Cluster UP/DOWN switches shorted to ground fault Problem with right keypad Look for pin A if shorted to ground or pin C.

B2224 Cluster UP/DOWN switches disconnected fault Problem with right keypad Look for pin B if disconnected to pin 16 on the cluster. Look for pin C if disconnected to pin 18 on the cluster C0042 iBR Brake Lever Sensor (BRLS) signals A open/shorted to ground Damaged sensor, damaged circuit wires, damaged connector or damaged iBR pins. Fault detected when the engine is running or stopped Check system circuits C03-6pos and C01-12pos. Check for 0.5 to 3 V on pin F and 0.25 to 1.5 on pin C.