Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) 194 smr2009-029 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION C0043 iBR Brake Lever Sensor (BRLS) signals B open/shorted to ground Damaged sensor, damaged circuit wires, damaged connector or damaged iBR pins. Fault detected when the engine is running or stopped Check system circuits C03-6pos and C01-12pos. Check for 0.5 to 3 V on pin F and 0.25 to 1.5 on pin C. C0073 iBR Torque request failure ECM software failure Perform ECM software update if available or replace ECM. C2100 iBR Sensors calibration is corrupted Incompatible firmware or memory failure Replace iBR unit.

Refer to the Service Manual for more details. C2100 iBR Actuator movement The iBR gate cannot move to the desired position. Clean and check for damage in the iBR gate and nozzle area. Refer to the Service Manual for more details. C2101 iBR Actuator movement warning The iBR gate cannot move to the desired position within expected time Clean and check for damage in the iBR gate and nozzle area. Refer to the Service Manual for more details. C2110 iBR iBR gate position sensor error iBR malfunction Replace iBR unit. Refer to the Service Manual for more details. C2110 iBR Angle position sensor warning iBR malfunction Replace iBR unit. Refer to the Service Manual for more details.

C2110 iBR iBR overheat iBR cooling system failure. iBR unit failure Check iBR cooling circuit. Replace iBR unit. Refer to the Service Manual for more details. C2110 iBR Monitoring CPU message time out or validity iBR malfunction Perform an iBR software update if available. Replace the iBR unit. Refer to the Service Manual for more details. C2110 iBR Monitoring CPU limp force iBR malfunction Perform an iBR software update if available. Replace the iBR unit. Refer to the Service Manual for more details. C2120 iBR Application calibration is corrupted Incompatible firmware or memory failure Perform an iBR software update if available. Replace the iBR unit.

Refer to the Service Manual for more details. C2121 iBR Application parameters corrupted (backup no. 1 or no. 2) Battery power lost or memory failure Perform an electrical system shut download to clear fault. Verify starting and charging system circuits. Refer to the Service Manual for more details.