Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) smr2009-029 195 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION C2122 iBR Last session interrupted Unexpected battery power lost Perform an electrical system shut down and clear fault. Verify starting and charging system circuits. Refer to the Service Manual for more details. C2130 iBR Motor current software breaker Motor current too high Clean and check for damage in the iBR gate and nozzle area. Refer to the Service Manual for more details. C2131 iBR iBR DC motor shorted to ground or 12 V iBR motor failure. iBR motor wires damaged Check iBR circuit A and B.
Refer to the Service Manual for more details. C2142 iBR Brake Lever Sensor (BRLS) signals A shorted to battery Damaged sensor, damaged circuit wires, damaged connector or damaged iBR pins. Fault detected when the engine is running or stopped Check system circuits C03-6pos and C01-12pos. Check for 0.5 to 3 V on pin F and 0.25 to 1.5 on pin C. C2143 iBR Brake Lever Sensor (BRLS) signals B shorted to battery Damaged sensor, damaged circuit wires, damaged connector or damaged iBR pins. Fault detected when the engine is running or stopped Check system circuits C03-6pos and C01-12pos. Check for 0.5 to 3 V on pin F and 0.25 to 1.5 on pin C.
C2144 iBR Brake Lever Sensor (BRLS) power shorted to battery Damaged sensor, damaged circuit wires, damaged connector or damaged iBR pins. Fault detected when the engine is running or stopped Check system circuits C03-6pos and C01-12pos. Check for 4.5 to 5 volts on sensor connector pin A & D. Refer to the Service Manual for more details. C2145 iBR Brake Lever Sensor (BRLS) power shorted to ground Damaged sensor, damaged circuit wires, damaged connector or damaged iBR pins. Fault detected when the engine is running or stopped Check system circuits C03-6pos and C01-12pos. Check for 4.5 to 5 volts on sensor connector pin A & D. Refer to the Service Manual for more details.
C2146 iBR Brake Lever Sensor (BRLS) signals A/B reading difference Damaged sensor, damaged circuit wires, damaged connector or damaged iBR pins. Fault detected when the engine is running or stopped Check system circuits C03-6pos and C01-12pos. Check for 0.5 to 3 V on pin F and 0.25 to 1.5 on pin C. C2150 iBR System current software breaker iBR input current too high Clean and check for damage in the iBR gate and nozzle area. Refer to the Service Manual for more details.