Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) smr2009-029 199 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION P0123 ECM TAS (Throttle Accelerator sensor) 1 fault (short circuit to battery) Damaged sensor, damaged circuit wires, damaged connector or damaged ECM pins. Check system circuits B-E1, B-K1, B-K3. Check for 0 volt on sensor connector pin E. Check for 5 volts on sensor connector pin D. Check for 0.5 to 3 volts on sensor connector pin F. Refer to the Service Manual for more details. P0127 ECM Intercooler system fault High air intake temperature detected. Fault detected when the engine is running and stopped.
Blocked intercooler water circuit Clean intercooler water circuit system. Refer to the Service Manual for more details. P0201 ECM Injection Power Stage fault - open line/Cylinder 1 Damaged injector, damaged circuit wires, damaged connector or damaged ECM output pins Check for 11.4 to 12.6 ohms between engine connector pin 2 and ECM connector pin A-K1. Check for 12 volts on pin 2 of injector connector. Check fuse 8 (refer to WIRING DIAGRAM). Check for damaged circuit wires. Refer to the Service Manual for more details.
P0202 ECM Injection Power Stage fault - open line/Cylinder 2 Damaged injector, damaged circuit wires, damaged connector or damaged ECM output pins Check for 11.4 to 12.6 ohms between engine connector pin 2 and ECM connector pin A-K1. Check for 12 volts on pin 2 of injector connector. Check fuse 8 (refer to WIRING DIAGRAM). Check for damaged circuit wires. Refer to the Service Manual for more details. P0203 ECM Injection Power Stage fault - open line/Cylinder 3 Damaged injector, damaged circuit wires, damaged connector or damaged ECM output pins Check for 11.4 to 12.6 ohms between engine connector pin 3 and ECM connector pin A-J1. Check for 12 volts on pin 2 of injector connector.
Check fuse 9 (refer to WIRING DIAGRAM). Check for damaged circuit wires. Refer to the Service Manual for more details.